2007 Arctic Cat ATVs 400/500/650/700 Service Manual, Page 96Get this manual
NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs ! CAUTION
After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side Components, and to In- stalling Top-Side Components
3Place the oil pump into position in the crankcase and secure with the three Phillips-head screws coated with blue Loctite #243Tighten to specifications
Installing Right-Side Components
AOil StrainerOil Pump BGear Shift Shaft
1Place the oil strainer with new O-ring into position beneath the crankcase and tighten securely with the Phillips-head cap screws
4Place the washer and pin into position on the oil pump shaft, install the oil pump driven gear, and secure with the circlipNOTE: Always use new circlip when installing the driven gear