2007 Arctic Cat 700 Diesel ATV Service Manual, Page 180Get this manual
3Remove the axle and nut securing the shift lever to the upper shift arm; then remove the shift leverAccount for spring and two O-rings4Using two open-end wrenches, remove the lock nut securing the shift rod to the upper shift armRemove the shift rod and discard the lock nutNOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut 3Place the spring into position between the upper shift arm and shift lever; then making sure the O-rings are in place on the axle, secure the shift lever to the arm with the existing axle and nut4Check shift lever adjustment (see Section 2); then tighten jam nut (A) securely5Install the left-side splash panel
INSTALLING 1Place the shift rod into position on the engine shift arm and secure with the existing E-clip2Using new lock nut (B), secure the shift rod to the upper shift arm; then using two open-end wrenches, tighten securely