2007 Arctic Cat 700 Diesel ATV Service Manual, Page 127Get this manual
3Remove the front wheels; then remove the front inner fender panels4Compress the hand brake; then engage the brake lever lock5Remove the cotter pin securing the hex nut; then remove the hex nut and washer AG926
NOTE: It is important to tighten this cap screw while the others are loose to ensure proper seating of the actuator
5Tighten the remaining cap screws; then connect the electrical plug to the main harness6Turn the ignition switch to the ON position and check the operation by shifting the selector switch several times7Secure the wiring harness to the frame with nylon cable tie; then install the inner fender panelKX041
6Release the brake lever lockNOTE: It is not necessary to remove the brake hoses from the calipers for this procedure