2007 Arctic Cat 700 Diesel ATV Service Manual, Page 118Get this manual
3With the starter button depressed, the meter must show 0.5-0.7 DC volts4With the starter button released, the meter must show DC volts5Connect the red tester lead to the yellowgreen wire; then connect the black tester lead to the orangewhite wire6With the starter button depressed, the meter must show DC voltsNOTE: If the meter does not show as specified, replace the switchcomponent, connector, or switch harness 4With the selector switch in the 4WD position, the meter must show an open circuitNOTE: If the meter does not show as specified, replace the front drive selector switch
VOLTAGE
NOTE: The battery must be connected when performing voltage tests
1Set the meter selector to the DC Voltage position2Connect the black tester lead to the negative battery terminal3Connect the red tester lead to the red wire on the harness side of the connector4Turn the ignition switch to the RUN position5The meter must show 12 DC voltsNOTE: If the meter shows other than specified, check the harness, connector, 30 amp fuse, and battery connections