2007 Arctic Cat 700 Diesel ATV Service Manual, Page 28Get this manual
TRANSMISSION NOTE: The transmission can be removed for servicing without removing the engineTo remove the transmission, use the following procedure
1Remove the front rack, inner front splash shields, foot pegs, and forward footwells; then remove the front body panel (see Section 8)2Remove three cap screws securing the front propeller shaft to the front differential input couplerDE090A
21Remove the transmission level stick mount and housing; then disconnect the throttle cable from the throttle control arm and unthread the throttle cable housingRoute the throttle cable away from the engine
3Remove four cap screws securing the rear propeller shaft to the output drive flange4Remove the transmission level stick housing and account for an O-ring5Drain the transmission lubricant into suitable container; then disconnect the transmission vent hose, gear shift position switch connector, speed sensor connector, and shift linkage6Remove the V-belt (see Section 2)7Remove the nut securing the driven pulley to the transmission input shaft; then remove the driven pulleyAccount for flat washer, square key, and four shims