2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 96Get this manual
CHECKINGINFLATING
1Using an air pressure gauge, measure the air pressure in each tireAdjust the air pressure as necessary to meet the specified inflation pressure2Inspect the tires for damage, wear, or punctures
! WARNING
Do not operate the ATV if tire damage existsMD2421
CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
NOTE: If repair is needed, follow the instructions found on the tire repair kit or remove the wheel and have it repaired professionallyNOTE: Be sure all tires are the specified size and have identical tread pattern
1Clean the wheels and hubs with parts-cleaning solvent2Clean the tires with soap and water3Inspect each wheel for cracks, dents, or bends4Inspect each tire for cuts, wear, missing lugs, and leaksINSTALLING
3Test drive the ATV on dry, level surface and note any pulling to the left or right during acceleration, deceleration, and brakingNOTE: If pulling is noted, measure the circumference of the front and rear tires on the pulling sideCompare the measurements with the tires on the opposite sideIf pulling is noted during braking only, check and adjust the brakes as necessary and recheck operation (see Section 2)