2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 91Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 91


3Slide brake backing plate assembly off the spindle shaft and secure it out of the way4Remove the cotter pin from the outer tie rod end; then while holding the flat on the tie rod end, remove the castle nutAccount for washer
8Remove the cap screws and self-locking nuts securing the A-arm to the frame

9Remove the A-arm

5Remove the tie rod end from the steering knuckle6Remove the rubber spindle pin boot; then remove the cotter pin and flanged castle nut from the spindle pinLower the steering knuckle assembly from the A-arm

Back to 2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual