2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 81Get this manual

2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual, Page 81

REMOVING REAR SPROCKET
1Secure the ATV on support stand to elevate the right rear wheel
! WARNING
Make sure the ATV is solidly supported on the support stand to avoid injury
2Remove the cotter pin from the castle nut on the right rear wheel hubKM238A

NOTE: Make sure the closed end of the master link clip faces the direction of the rotation of the chain
3Remove the wheel hub castle nut; then slide the wheel and hub off togetherAccount for the washer
MD2363 MD1854

REMOVING FRONT (COUNTERSHAFT) SPROCKET

4Remove the drive chain master link clip, link plate, and master link; then allow the drive chain to roll off the rear sprocketAccount for four O-rings on the master link

Back to 2006 Arctic Cat Y-6/Y-12 50cc and 90cc Service Manual