2006 Arctic Cat DVX 400 Service Manual, Page 101Get this manual

2006 Arctic Cat DVX 400 Service Manual, Page 101

NOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness Neutral Switch
RESISTANCE

RESISTANCE (LO Beam)

1Set the meter selector to the OHMS position2Connect the red tester lead to the white wire; then connect the black tester lead to the gray wire3With the dimmer switch in the LO position, the meter must show an open circuitNOTE: If the meter reads resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness
! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter

Back to 2006 Arctic Cat DVX 400 Service Manual