2006 Arctic Cat DVX 400 Service Manual, Page 96Get this manual
Testing Electrical Components All of the electrical tests should be made using the Fluke Model 73 Multimeter (pn 0644-191) and when testing peak voltage, the Peak Voltage Reading Adapter (pn 0644-307) must be usedIf any other type of meter is used, readings may vary due to internal circuitryWhen troubleshooting specific component, always verify first that the fuse is good, that the bulbs are good, that the connections are clean and tight, that the battery is fully charged, and that all appropriate switches are activatedNOTE: For absolute accuracy, all tests should be made at room temperature of 68 F
Brakelight Switch
(Rear Brake)
The switch connector is the two-prong connector located along the upper right frame railRESISTANCE (Switch Connector)
! CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeterNOTE: The brake pedal must be depressed for this testAlso, the ignition switch must be in the OFF position
Brakelight Switch