2006 Arctic Cat DVX 400 Service Manual, Page 92Get this manual
2Place the new shaft seal into the housing; then tap it down until it is fully seatedNOTE: large, deep socket can be used to drive the seal down evenly 3Install new O-rings in the water pump housing; then install the water pump with impeller into the clutch cover
2Install the clutch cover and tighten the cap screws securely; then install the master cylinder mounting bolts and tighten to specifications (see Section 10)3Connect the brake switch spring and the brake pedal springSP305
4Install the washer (1), drive pin (2), and driven gear (3); then install the circlip (4)Make sure the circlip is properly seated
4Connect the radiator hose; then fill the cooling system with the recommended amount of coolant