2006 Arctic Cat DVX 400 Service Manual, Page 56Get this manual
2If damaged, the camshaft must be replaced Servicing Left-Side Components
STARTER CLUTCH
To replace the starter clutch, use the following procedure1Hold the rotorflywheel using 27 mm offset wrench; then remove the six Allen-head cap screws securing the starter clutch housing
3Install the starter driven gear (1) into the starter clutch; then check that the rotor (2) turns in the direction of the arrow (3) while holding the driven gearCheck in several positions and make certain the rotor never turns opposite the arrow
2Install the new starter clutch making sure the flange side (A) is directed toward the rotorflywheel; then install the six Allen-head cap screws and tighten securelyApply engine oil to the starter clutch assembly