2006 Arctic Cat DVX 400 Service Manual, Page 39Get this manual
3Remove the starter driven gear (2), two alignment pins (3), and the cover gasket (4)Account for two thrust washers from the driven gear 7Remove the Allen-head cap screws securing the neutral switch housing (1); then remove the switchAccount for one O-ring (2), two switch contacts (3 and 4), and the two springs behind the switch contacts
NOTE: If the right-side components are to be removed, do not remove the rotorflywheelProceed to step 7
4Using 27 mm offset box-end wrench, hold the rotorflywheel; then remove the nut securing the rotorflywheel to the crankshaft
NOTE: To aid in installing, it is recommended that the assemblies be kept together and IN ORDER
Right-Side Components