2006 Arctic Cat DVX 400 Service Manual, Page 23Get this manual
4Make vertical marks which intersect the horizontal marks on the aiming surface directly in front of the headlights5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW BEAM6Observe each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below the horizontal mark on the aiming surface CReverse switch reverse indicator light illuminatesDHiLo switch headlight beam bright and dimEBrake switches rear brakelight illuminatesFNeutral switch neutral indicator light illuminates when transmission is in neutral
Indicator Lights
Each time the ATV is used, the lights should be checked for proper functionUse the following for reference
ATV2051B
7Adjust the headlight assembly until correct aim is obtainedALoosen the adjuster nut; then move the stud up or down in the slot until proper aim is obtainedBTighten the adjuster nut securelyATV2007
1Reverse Indicator red light will illuminate when the transmission is shifted into reverse gearThe light will go off when shifted out of reverse2Neutral Indicator green light will illuminate when the transmission is in neutral and the ignition switch is onThe light will go out when shifted into any gear other than neutral3Temperature Indicator red light will illuminate if the engine overheatsThe light should be off during normal operation