2006 Arctic Cat ATVs factory service and repair manual, Page 466Get this manual
4Apply grease on the drive axle splines; then install the hub assembly onto the drive axle 8Slide the hub out of the knuckle and set aside
9Remove the cap screws and lock nuts securing the knuckle to the A-armsDiscard the lock nutsNOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut
Secure the hub assembly with the nutTighten only until snugSecure the brake caliper to the knuckle with the two cap screws (right side only)Tighten the auxiliary caliper to specificationsTighten the hydraulic caliper to specifications1NOTE: Ensure that the brake hose and brake cable are properly routed and secured to the upper A-arm
10Remove the cap screws and lock nuts securing the A-arms to the frame; then remove the A-arms1 NOTE: If removing the upper right A-arm, it will be necessary to disconnect the brake hose and brake cable from the A-arm
CLEANING AND INSPECTING
1NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary