2006 Arctic Cat ATVs factory service and repair manual, Page 451Get this manual
1 NOTE: Pull the bearing ring out of the housing until it contacts the circlip; then slide the ring in half wayThis will purge air from the housing and ensure the bearing is packed properly 4If the brake calipers were removed, position them on the knuckle and secure with existing cap screwsTighten the auxiliary brake caliper cap screws to specificationsTighten the hydraulic brake caliper cap screws to specifications5Pump up the hand brake lever; then engage the brake lever lock6Tighten the hub hex nut (from step 3) to specifications; then install and spread new cotter pin making sure each side of the pin is flush to the hub nut
7Slide the boot over the housing; then using the boot clamp pliers, secure the boot with the clamp
7Install the wheelTighten to specifications
8Remove the ATV from the support stand and release the brake lever lockINSTALLING FRONT DRIVE AXLE (4x4 Models)