2006 Arctic Cat ATVs factory service and repair manual, Page 449Get this manual
7Using side-cutters (or suitable substitute),
remove both outside boot clamps from the shaftNote the position of the different-sized clamps for assembling purposes
4Note the difference inside each bearing ring end for assembling purposes; then remove the bearing ring1 NOTE: The recess of the bearing must face toward the housing
8Apply 40 grams (113 of contents) of grease from the Grease Pack 0441-1731 into the knuck' les and the new outside boot
5Inspect the splines of the shaft, the bearing ring, and the housing for damageIf any damage is apparent to the splines, the bearing ring, andlor the housing, the drive axle must be replaced as an assembly1 NOTE:
l NOTE: Grease Pack (pln 0441-173) contains 120 grams of greaseThe inside joint (double-offset) requires approximately 70-90 grams of grease and the outside (bell-type) requires approximately 35-55 gramsWhen replacing boots, use of the pack for inside boots and 113 of the pack for outside boots