2006 Arctic Cat ATVs factory service and repair manual, Page 413Get this manual
3With the engine running at the specified RPM, all wire tests must show 60 A.Cvoltsrn
Do not run the engine at high RPM for more than 10 seconds
1 NOTE: If both stator coil tests failed, check all connections, etc and test againIf no voltage is present, replace the stator assembly
RESISTANCE (Stator Coil)
4If the differential lock engages (front wheels locked) and the voltage does not drop to 0, the switch is faulty and must be or replaced,
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter
1Set the meter selector to OHMS position
Magneto Coils
(400500650 )
2Test between the three black wires for total of three tests3The meter reading must be within specification
VOLTAGE (Stator Coil Output)
Regulated
RESISTANCE (Trigger Coil)
1Set the meter selector to the DC Voltage posi21Set the meter selector to the OHMS position