2006 Arctic Cat ATVs factory service and repair manual, Page 393Get this manual
4While holding the bearing housing assembly in position on the engine, slowly rotate the impeller until the impellerlshaft engages properly with its slot in the driven shaftNOTE: The bearing housing will be flush with the engine when the two shafts are properly engaged CAUTION
Failure to properly engage the two shafts could cause serious enaine damaaeCC788A
5With the bearing housing assembly in position on the engine, place the cover (with O-ring installed) into position on the housing; then loosely secure with the two Phillips-head cap screwsINSTALLING 1Secure the water pump to the engine with the two cap screws tightened securely; then tighten the two Phillips-head cap screws securely
Place the footrest into position on the frame and loosely secure with four cap screws; then secure the front and rear fenders to the footrest with the four tom-head cap screwsTighten the four tom-head cap screws securely; then tighten the remaining cap screws to specificationsFill the engineltransmission with the proper amount of recommended oilFill the cooling system with the proper amount of recommended coolantH NOTE: While the cooling system is being filled, air pockets may develop; therefore, run the engine for five minutes after the initial fill, shut the engine off, and then fill the cooling system