2006 Arctic Cat ATVs factory service and repair manual, Page 346Get this manual
1NOTE: Do not move the connecting rod with plastigauge installed or the reading will be compromised 8Remove the connecting rods and read the clearance with the gauge providedThe clearance must be 0.028-0.052 mm (0.0011-0.0020 in standard with maximum service limit of 0.09 mm (0.0035 in
12Install the idler shaft (A) with gear assembly (B), spacer (C), and spacer (D); then install spacer (E) with the stepped side (F) directed outward
9Clean off all traces of plastigauge from the crankshaft and inserts; then assemble on the crankshaft using clean, molybdenum disulfide oil on the inserts (A)Make sure that the "OUT" marks (B) on both connecting rods are directed towards the outside of the crankshaft and the grooves (C) of the cap and connecting rod are on the same side13Install spacer, toothed washer (A), and the circlip on the driven shaft