2006 Arctic Cat ATVs factory service and repair manual, Page 287Get this manual
crankcase halves, turn the shift cam to ensure all gears shift properly 1 NOTE: Prior to joining
4From the right side, install the three case half mm cap screws; then tighten only until snugl NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
Joining Crankcase Halves
1Place the O-ring in the left-side crankcase half and verify that the washer is on the idler shaft; then apply Three Bond Sealant (pln 0636-070) to the mating surfacesPlace the right-side half onto the left-side half
5From the left side, install the seven case half mm cap screws noting the location of the wiring form; then tighten only until snug1 NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs