2006 Arctic Cat ATVs factory service and repair manual, Page 187Get this manual
1 NOTE: Inspect the inside of the left-side cover for any shaft washers that may have come off with the coverMake sure they are returned to their respective shafts and that the starter idler gear spacer is on the shaft or in the cover 6Remove the two cap screws securing the water pump to the engine; then remove the water pump
9Remove the nut securing the magneto rotor to the crankshaft; then install the magneto rotor puller adapter1NOTE: The
puller has left-hand threads
10Using Magneto Rotor Remover Set (pln 0444-075), remove the rotorlflywheel assembly from the crankshaftAccount for the key; then remove the starter clutch gear assembly and washerB AT THIS POINT