2006 Arctic Cat ATVs factory service and repair manual, Page 129Get this manual
BRemove each ring by working it toward the dome of the piston while rotating it out of the groove 1 1
B AT THIS POINT To service piston, see Servicing Top-Side Components sub-section
B AT THIS POINT [To service center crankcase components only, proceed to Removing Left-Side Components
Left-Side Components
1 NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment
B AT THIS POINT To service any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in each sub-section
1 NOTE: The engineltransmission does not have to be removed from the frame for this procedure
3Lay the engineltransmission on its right sideRemove the 15 left-side cover-to-crankcase mounting cap screws noting the location of the mm cap screw with the washer near the middle of the left-side coverKeep the different-lengthed mm cap screws in order for installing purposes