2006 Arctic Cat ATVs factory service and repair manual, Page 105Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 105

I NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs A CAUTION

After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side Components, and to In- stalling Top-Side Components
Installing Right-Side Components
Oil StrainerIOil Pump Gear Shift Shaft

4Place the washer and pin into position on the oil pump shaft, install the oil pump driven gear, and secure with the circlipI NOTE: Always use new circlip when installing the driven gear

Back to 2006 Arctic Cat ATVs factory service and repair manual