2004 Arctic Cat ATVs factory service and repair manual, Page 482Get this manual
4Secure the lower eyelet of the shock absorber to the upper A-armTighten nut to 4.8 kg-m (35 ft-lb)5Secure the A-arm assemblies to the frame mounts (from step 2)Tighten the cap screws to 4.8 kg-m (35 ft-lb) Do not tighten the nut beyond the 4.8 kg-m (35 ft-lb) specification or the shock eyelet or mount WILL be damaged
6Install the knuckle assembly onto the ball joints and secure with cap screwsTighten to 4.8kg-m (35 ft-lb)
9Insert the hub seal onto the drive axle; then position it into the hub
7Install the tie rod end and secure with the nutTighten to 4.2 kg-m (30 ft-lb); then install new cotter pin and spread the pin to secure the nutI NOTE: During assembly, new cotter pins should be installed