2004 Arctic Cat ATVs factory service and repair manual, Page 464Get this manual
WNOTE: The large grease pack is for the inner drive axle bearing and boot assembly 7Slide the boot over the housing; then using the boot clamp pliers7secure the boot with the clamp
4Install the bearing onto the shaft making sure the recess of thefacing the housingis
8Inspect the axle components for correct positioning of the four clampsAlso7 inspect the boots for being correctly positioned on the shaft
The bearing ring must go onto the shaft with the side without splines facing toward the small clamp of the inner boot or severe damage will result
5Secure the bearing ring with the circlip making sure the sharp side of the circlip faces away from the boot