2004 Arctic Cat ATVs factory service and repair manual, Page 461Get this manual
W NOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut W NOTE: It is not necessary to remove the brake hose from the caliper for this procedure
8While holding the drive axle stationary, pull the top of the knuckle out and down until it is free of the drive axle9Place drain pan under the to contain any oil leakage; then using slide hammer, remove the drive axle
5Remove the brake caliperW NOTE: Support the caliperDo not allow the caliper to hang from its hose
he caliper should be supportedIf the caliper allowed to hang from its hose, damage may occur