2004 Arctic Cat ATVs factory service and repair manual, Page 319Get this manual
18Remove the starter idle gear (G) from the pin; then remove the pin 20Remove the two cap screws securing the starter to the crankcase; then remove the starterAccount for the wiring forms
19Remove the Phillips-head screws securing the shift-indicator sending unit; then remove the sending unitAccount for an O-ring, neutral contact, and spring
c AT THIS POINT
To service center crankcase components only, proceed to Removing Right-Side Components
Right-Side Components
I NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician should use discretion and sound judgment