2004 Arctic Cat ATVs factory service and repair manual, Page 296Get this manual
6Install the magneto cover and secure with existing hardwareTighten to 1.1 kg-m (8 ft-lb) 7Place the speedometer gear housing and gasket into position and secure with the two cap screwsighten securely-
Make sure the speedometer gear and output shaft gear match up during assembly
8Place the water pump into position and secure with two cap screwsTighten securely
10Install the shift arm on the shift arm shaft making sure the scribed marks (from removing) are alignedTighten securely11Place the starter cup into position on the crankshaft making sure newlubricated O-ring is inside the cup flange nut to 3.5 kg-m the (25 ft-lb)