2004 Arctic Cat ATVs factory service and repair manual, Page 237Get this manual
20Install two alignment pins and place the V-belt cover gasket into position on the clutch coverInstall the V-belt cover noting the position of the long cap screws and rubber washer and two wire formsIn crisscross pattern, tighten cap screws to 1.1 kg-m (8 ft-lb) I NOTE: The arrows on the V-belt should point forward
18Making sure the eight movable drive face rollers are in position, pinch the V-belt together near its center and slide the spacer and movable drive face onto the shaftCoat the threads of the nut with red Loctite #271 and secure the movable drive faceTighten the nut to 10.4-11.8kg-m (75-85 ft-lb)
Installing Left-Side Components