2004 Arctic Cat ATVs factory service and repair manual, Page 187Get this manual
11Route the two vent hoses through the slots in the frame12Place the rear outnut shaft into nosition on the rear output joint; then install the four cap screws and tighten to 2.8 kg-m (20 ft-lb) 16Place the gear shift lever into position on the shaft on the engine; then secure with the pinch screw and lock nut
13On the 4x4, place the speedometer cable into position and tighten the knurled nut
17Place the footrests into position on the frameTighten the 10 mm cap screws to 5.5 kg-m (40 ft-lb) and the mm cap screws to 2.8 kg-m (20 ft-lb); then secure the fender extensions to the footrests with existing hardware18Place the exhaust pipe into position inside the frame and connect to the muffler at the junctureI NOTE: If the muffler was removed, see Section 8