2004 Arctic Cat ATVs factory service and repair manual, Page 177Get this manual
10Install the drive idler gear with one spacer and one washer 13Install the two alignment pins into the left crankcase half11Install starter idler gear #2 and pinI NOTE: Make sure that three washers and two alignment pins are in place
12Install the starter clutch gear assembly onto the crankshaftPlace the key into its notchPlace the magneto rotor into position on the crankshaft; then install the magneto rotor nut on the crankshaft and tighten until the rotor is properly seatedTighten to 16 kg-m (116 ft-lb)