2004 Arctic Cat ATVs factory service and repair manual, Page 173Get this manual
The clutch sleeve hub and the clutch pressure plate must be seated in the proper positionIf any of the incorrect positions are used, the hub and plate will have clearance between them and they will not operate properly 11Simultaneously, place the primary clutch assembly and the starter clutch housing on their respective shafts making sure the sleeve is properly positioned in the primary assembly9Place the chain into the crankcase; then secure it from the top side with wire for ease of installing
10Install the primary driven washers and shims onto the driveshaft and crankshaft
I NOTE: After placing the primary clutch assembly onto the shaft, pull out on the pressure plate tower to ensure the pressure plate has engaged the clutch hub properly and make sure the plates (drive and driven) are brought together tightly prior to tightening the nut securing the clutch assembly