2004 Arctic Cat ATVs factory service and repair manual, Page 170Get this manual
10Install the two gear shift fork shafts; then verify that the two crankcase half alignment pins are in placeI NOTE: Prior to joining crankcase halves, turn the shift cam to ensure all gears shift properly
4From the left side, install the three case half mm cap screws (two inside the case); then tighten only until snugINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
Joining Crankcase Halves
1Verify that the shim washer is on the idler shaft; then apply Three Bond Sealant (pln 0636-070) to the mating surfacesPlace the right-side half onto the left-side halfCC981
5From the left side, install the seven case half mm cap screws; then tighten only until snugINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs