2004 Arctic Cat ATVs factory service and repair manual, Page 39Get this manual
4To replace the brake pads, use the following procedureARemove the wheelBRemove the cap screws securing the caliper to the bracket; then remove the cotter pin securing the pads and remove the pads 1With the engine off7transmission in neutral, and the reverse lever in the forward position, press the brake pedal and attempt to movi the A
ATVOO88E
2If the rear wheels are locked, it is adjusted properly3If the rear wheels are not locked7 it must be adjusted (set up)ADJUSTING
CInstall the new brake pads; then secure with the pin and cotter pinSpread the cotter pinDSecure the caliper to the knuckle andlor axle housing with the cap screwsTighten to 2.8 kg-m (20 ft-lb)
To adjust (set up) the auxiliary brake7use the following procedureWNOTE: Removal of the right, rear wheel enhances access to the brake components
1Loosen the right-hand jam nut (wheel-side when viewing from behind) of the adjuster arm