2004 650 Twin Arctic Cat ATV Service Manual, Page 21Get this manual
TAILLIGHT-BRAKELIGHT
To replace the taillight-brakelight bulb, use the following procedure1Remove the two screws and remove the lens cover2Push the bulb in and turn it counterclockwise3Install the new bulb by turning it clockwise while pushing in4Install the lens coverAF926A
! CAUTION
Tighten the lens cover screws only until they are snugCHECKINGADJUSTING HEADLIGHT AIM
7Adjust each headlight until correct aim is obtainedAHorizontal Loosen nut (A) and adjust for proper aimingTighten the nut securelyBVertical Loosen nut (B) and adjust for proper aimingTighten the nut securely
The headlights can be adjusted vertically and horizontallyThe geometric center of the HIGH beam light zone is to be used for vertical and horizontal aiming1Position the ATV on level floor so the headlights are approximately 6.1 (20 ft) from an aiming surface (wall or similar aiming surface)NOTE: There should be an average operating load on the ATV when adjusting the headlight aim