2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 285Get this manual
4Using plastic mallet, lightly tap the case halves together until cap screws can be installed5From the right side, install the mm cap screws; then tighten only until snug NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6From the left side, install the remaining mm cap screws (two inside the case); then tighten only until snugCC693
NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
2Lightly oil all bearings and grease all shafts in the right-side crankcase
7From the left side, install the eight case half mm cap screws; then tighten only until snug NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
8From the right side, install the mm cap screws; then tighten only until snug NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs