2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 155Get this manual
PRIMARY CLUTCH ASSEMBLY (InspectingMeasuringAssembling)
NOTE: Prior to inspecting and measuring components, it is recommended that all components be removed from the primary gear assembly and be cleaned NOTE: When removing components from the primary gear assembly, account for the bushing that fits into the primary gear
2Drive plate thickness must be minimum of 2.62 mm (0.103 in3If the fiber plate tabs are damaged, the plate must
be replaced4Inspect the clutch sleeve hub for grooves or
notchesIf grooves or notches are present, replace the hubInspecting Starter Clutch Shoe
1Inspect the starter clutch shoe for uneven wear,
InspectingMeasuring Clutch Driven Plate Warpage
1Inspect each driven plate for warpage and bum
chips, cracks, or bums2Inspect the groove on the shoe for wear or