2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 109Get this manual
CStator AssemblyCover DStarter Cup ERecoil Starter NOTE: Steps 1-16 in the preceding sub-section must precede this procedure
17Install the magneto rotor nut on the crankshaft and tighten until the rotor is properly seated; then tighten to 16 kg-m (116 ft-lb)
22Place the gasket and recoil starter assembly into position on the left-side cover noting the location of the single washer; then tighten the cap screws to 0.8 kg-m (6 ft-lb)
18Place the gasket and left-side cover into position on the crankcase making sure the alignment pins are in place19Install the cap screws to secure the left-side cover noting the location of the different-sized cap screws; then only finger-tighten at this time20Place the starter cup into posItIOn on the crankshaft making sure new, lubricated O-ring is inside the cupTighten the nut with lock washer to 3.5 kg-m (25 ft-lb)