2003 Arctic Cat ATVs from 250cc to 500cc Service Manual, Page 60Get this manual
Removing Left-Side Components ARecoil Starter BStarter Cup CCoverStator Assembly
1Remove the cap screws securing the recoil starter assembly to the left-side cover; then remove the starter noting the location of the single washerAccount for the gasketIf'
3Lay the enginetransmission on its right side; then remove the cap screws securing the left-side cover to the crankcase and note the location of the different-sized cap screws4Remove the left-side cover wstator assemblyAccount for gasket, two alignment pins, and starter idler gear spacer NOTE: Inspect the inside of the left-side cover for any shaft washers that may have come off with the coverMake sure they are returned to their respective shafts and that the starter idler gear spacer is on the shaft or in the cover NOTE: For steps 5-21, refer to illustration CC846A (4x4) or to illustration CC873A (2x4) NOTE: To aid in installing, it is recommended that the assemblies are kept together and IN ORDER