2001 Arctic Cat ATVs factory service and repair manual, Page 402Get this manual
6Place the loop on the lower end of the reverse cable into the slot in the reverse actuator armSecure the cable to the actuator with pin and E-ringADJUSTING NOTE: Mark the reverse shift shaft to the reverse actuator arm to aid in reassembly Fig9-36
1Remove the cap screw securing the reverse actuator arm to the reverse shift shaft; then slide the arm off the reverse shift shaftFig9-34
3Tighten the jam nut securing the upper reverse cable housing to the frame4Loosen the jam nut securing the lower reverse cable housing to the frame; then while aligning the reverse actuator with the reverse shift shaft, lengthen or shorten the cable length until the actuator slides freely onto the shift shaft5Tighten the jam nut securing the reverse cable housing to the frameSecure the reverse actuator to the shift shaft with the cap screwFig9-37