2001 Arctic Cat ATVs factory service and repair manual, Page 393Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 393

Hand Brake Lever Master Cylinder Assembly NOTE: The master cylinder is non-serviceable component; it must be replaced as an assemblyREMOVING

! CAUTION
Brake fluid is highly corrosiveDo not spill brake fluid on any surface of the ATV
3Remove the clamp screws securing the brake assembly to the handlebar; then remove the assembly from the handlebarFig9-3

1Slide piece of flexible tubing over one of the wheel bleeder valves and direct the other end into containerRemove the reservoir cover; then open the bleeder valveAllow the brake fluid to drain completelyFig9-1

Back to 2001 Arctic Cat ATVs factory service and repair manual