2001 Arctic Cat ATVs factory service and repair manual, Page 347Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 347

INSTALLING
Fig6-172

1Maneuver the axle assembly forward making sure propeller shaft splines engage properly and the final drive boot is positioned over the drive housing2Place the rear of the swing arms into position on the axle housings and case; then secure with four cap screws and hex nutsTighten to 4.8 kg-m (35 ft-lb)Fig6-170

! CAUTION
Care should be taken not to damage or kink the brake hose(s) when installing the caliper(s)

3Place the shock absorber into the shock eyelets and secure using the cap screws and hex nuts tightened to 4.8 kg-m (35 ft-lb)Fig6-171

Back to 2001 Arctic Cat ATVs factory service and repair manual