2001 Arctic Cat ATVs factory service and repair manual, Page 335Get this manual
Fig6-108
EMaximum runout must be within range of 0.00-0.05 mm (0.00-0.002 inNOTE: If the backlash range is not within tolerance, remove or add shim(s) on the drive bevel gear assemblyAdding shim(s) will increase backlash; removing shim(s) will decrease backlashFig6-111
42Check drive bevel geardriven bevel gear backlash using the following procedureAInstall the driven bevel gear into the differential housingFig6-109
43Check driven bevel geardriven output shaft bearing clearance using the following procedureAMeasure the width of suitable straightedge; then record the width measurementFig6-112