2001 Arctic Cat ATVs factory service and repair manual, Page 334Get this manual
Fig6-103
39The maximum preload must be within range of 5-9 kg-cm (4.3-7.8 inlb)If the preload is beyond the specified range, the drive bevel gear nut must be loosened and tightened to 9-11 kg-m (65-79.5 ft-lb)NOTE: After the nut has been tightened, redo the preload range test to verify the preload rangeNOTE: If the bearing(s) or shim(s) have been replaced, the backlash must be checked and adjusted if necessary
40Install the differential case assembly into the differential housingFig6-106
36Place any shims removed onto the drive bevel gear assembly, place the O-ring into the groove, and apply low temperature grease to the O-ring; then install the drive bevel gear assembly into the differential housing37Secure the drive bevel gear assembly with the cap screws coated with green Loctite #270Tighten securelyFig6-104