2001 Arctic Cat ATVs factory service and repair manual, Page 299Get this manual
2Connect the red tester lead to the orangewhite wire; then connect the black tester lead to the yellowgreen wire3With the starter button depressed, the meter must show 0.50.7 ohm4With the starter button released, the meter must show an open circuit5Connect the red tester lead to the yellowgreen wire; then connect the black tester lead to the orangewhite wire6With the starter button depressed, the meter must show an open circuitNOTE: If the meter does not show as specified, replace the switchcomponent, connector, or switch harnessRESISTANCE (Emergency Stop)
5Depress and hold the reverse override buttonThe meter must show less than ohmNOTE: If the meter does not show as specified, replace the switchcomponent, connector, or switch harness
Magneto Assembly
VOLTAGE (Charging CoilsOutput)
1Set the meter selector to the D.CVoltage position2Connect the red tester lead to the positive battery post; then connect the black tester lead to the negative battery post3With the engine running at constant 5000 RPM (with the headlights on), the meter must show 14-15.5 D.Cvolts