2001 Arctic Cat ATVs factory service and repair manual, Page 298Get this manual
2Connect the red tester lead to the redblack wire; then connect the black tester lead to the blue wire3The meter must show battery voltageNOTE: If the meter fails to show voltage in any of the above tests, the connector, fuse, switch, or wiring harness must be replaced 9The meter must show less than ohm10With the switch in the OFF position, connect the red tester lead to the red wire and the black tester lead to each of the remaining wires (orange and gray)The meter must show an open circuit on both wiresNOTE: If the meter shows more than ohm of istanceroubleshoot or replace the switchcomponent, the connector, or the switch wiring harness
Ignition Switch
The connector is the green one beneath the consoleTo access the connector, the speedometer and instrument pod must be removedVOLTAGE NOTE: Perform this test on the lower side of the connector
Handlebar Control Switches
The connector is the yellow one in front of the steering postTo access the connector, the front rack and front fenders must be removed (see Section 8)NOTE: These tests should be made on the top side of the connector