2001 Arctic Cat ATVs factory service and repair manual, Page 294Get this manual
FIRST GEAR
1Connect the jumper positive wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to the first gear terminal on the gear position light connector3The first gear position indicator light should illuminateSECOND GEAR
2Pull the instrument pod wiring with light bar upward and install the light bar into the instrument pod3Secure the instrument pod with existing hardware; then secure the instrument pod wiring to the steering post using cable tie
Gear Position Switch
(Manual Transmission)
1Connect the jumper positive wire to the power source terminal on the indicator light connector2Connect the jumper ground wire to the second gear terminal on the gear position light connector3The second gear position indicator light should illuminateTHIRD GEAR NOTE: The ignition switch must be in the OFF positionAlso, the tests should be made at the white connector directly behind the reverse leverTest the lower end of the connector (coming from the switch)