2001 Arctic Cat ATVs factory service and repair manual, Page 255Get this manual

2001 Arctic Cat ATVs factory service and repair manual, Page 255

NOTE: Check float arm height by inverting the carburetor freeing the float arm; then measuring with caliper the height when the float arm is in contact with the needle valveFloat arm height should fall within specificationsTo adjust, bend the actuator arm tabFloat Arm Height 250 cc 400 cc Fig4-34

6Install the idle RPM speed adjuster cable7If the jet needle E-clip was removed, snap the E-clip into the proper groove at the top of the jet needle; then with the E-clip in position, slide the plastic washer up from the bottom of the jet needle and tight against the E-clipFig4-37