2001 Arctic Cat ATVs factory service and repair manual, Page 223Get this manual
+ Click Here to Go Back RemovingDisassembling
! CAUTION
During the disassembly procedure, make sure all spring tension is released before continuing
1Remove the cap screws securing the recoil starter assembly to the left-side cover; then remove the starter noting (on the 250300 cc) the location of the single washer closest to the center of the crankcaseAccount for gasketFig3-830
3Remove the nutFig3-833
Fig3-831
4Slowly release the friction plate and lift the plate with ratchet guide free of the recoil housing; then remove the ratchet guide from the friction plateFig3-834